Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello in the community.I am faced with the following problem and I wonder if somebody could help me.after having loaded a WS-C2960X-24PD-L switch with up-to-date-ios (c2960x-universalk9-tar.152-4.E8.tar) i tried to reload the switch with reload comma...
Hi everybody,
with the config command 'show environment temp status' you get to see a "System temperature from the Switch.
the question:
at which Point of the Switch is this temperature measured? is this the processor temperature? or the power supply...
Hello everybody,I was faced with the following situation:I downgraded IOS from the release referred to in the title to the as of today Cisco recommended Version (12.2.55-SE10)The Switches are C2960G-24TC-L and the method I used was via CNA ver 6.1 (C...
Hello everybody,I would appreciate your comments to the following scenario:Intending to reduce unnecessary traffic in an access layer redundant topology I would consider implementing the following:Enable portfast globally on a access layer switchEnab...
Hi everybody,I encountered the following problem and would appreciate your assistance.Using CNA I upgraded the IOS of a C3750G-24TS-S MLS (existing version 12.1(14)Ea.1-SMI with the latest available on Cisco site 12.2(55)SE8 IP services.The switch wa...
Most probably you have solved this by now. But as a future reference: at exec mode enter #show linethere will be more than 1 line connected on the device.clear all lines not used by entering: #clear line <No to clear> Te device will not let you clea...
Leo,Thank you you for your immediate responses!i will RMA the switch or contact a Cisco Partner and let the community know of the outcome, if i get one.
Hi Paul,thanks a lot for trying to help. But the switch does not go past the POST!I will try to load without console cable but this was the initial problem.The switch was upgraded with Cisco recommended ios and it failed the reload. And there was no ...
Hi Leo,Thx a lot for your time to reply. However, the Switch is not even reaching the stage where it checks its ROM.The error i am getting is far before this stage.
