Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi there guys, we have a 2921 with a VIC2-4FXO out on a site in India the clients phones register over a managed MPLS network to a centralised CUCM clusterthe client wanted to break local calls out of analogue lines; the router is registered as an MG...
hi all, i am trying to apply some QOS to prioritise VOIP traffic over a VPN to a headend PBX i have found numerous examples of this however they utilise the "shape average" command which after some research is not available on the next gen firewall r...
good morning all, i recently installed a UC560 for a client on a local site using Cisco Configuration Assistant. Version: 3.2 (2) system details:UC560running latest revision 8.6.1all inbound/outbound calls via siptrunk system is all working as desire...
howdy all, just want to confirm my configuration scenario:ASA5505 running 8.4(2) customer has a /29 public IP allocation assigned to there connection from the ISP lets for example say this is 1.2.3.0/291.2.3.1 - is the gateway address the ISP has iss...
good afternoon all, wondering if someone could help confirm my thinking we recently inherrited a customer contract with a UC560 the previous supplier had messed up the install so we have been brought in to get things working it has been a while since...
good afternoon,having read the official ASA manual all examples given use the "priority-queue" command which when using ether channel is not possiblei see on amazon that the new revision of the ASA book is coming out shortly which should hopefully ad...
hey there, same thing applies if i enter "priority-queue ?" i only get the option of the management interface see attached------- !priority-queue outside!service-policy police-priority-policy interface outside!
hi julio,thanks again for responding the "Hierarchical method" again uses the "shape average" command which is not available in the next gen firewalls which i am using specifically ASA5515.i could perhaps use the "Standard Priority Queuing" method ho...
