Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
anyone know how to stop this?-am controlling cfa's with csswhat stops person A (offnet), calling person B (onnet), person A tells person B to transfer them to person C (offnet-long distance) - how can i differientate and stop this?thanks.charles
Does this effectively alleviate the requirement to have multiple pots dial peers - one to reference each voice port? Thanks!voice-port 1/0/0 trunk-group OUTBOUND!voice-port 1/0/1 trunk-group OUTBOUND!voice-port 1/1/0 trunk-group OUTBOUND!voice-port ...
In an frf.8 environment, virtual templates are used for atm--->frame-relay qos. doc-cd says that ppp-multilink interfaces automatically enforce a hard limit tx-ring 2.....my question: is it still necessary to reduce the tx-ring on the atm subinterf...
Hi - Did you ever get the polycom sip 501's to work with cm 5.0? Heard of anyone getting them to work with cm 6.x?What did you have to do to get them to work?THanks.Charles
hmm...true multicast?it is more likely unicast from devices that are attempting to register (or have registered successfully - ip phones can use sccp as a control protocol when talking to their cm) with cm and cm has auto registration turned off (on ...
you may want to check your gw type (h323 or mgcp) and the associated bind source interface commands.there is an mgcp bind source (for control and/or media) and also an h323 bind source address.
if i remember correctly - there was a problem when running message integrity check and roaming with leap. are you running mic?you may try disabling mic and see if your roaming problems still exist.
