Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a really strange problem. I was installing a new UPS system and I unplugged my 2 2950 pwr xl swtiches. They were only out for a minute. After I plugged them back in I can't make any outbound calls to the pstn. Inbound still works fine. I...
Hello,I purchased a second hand cisco aironet access point on Ebay and I am having trouble getting into the configuration program. I have reset the device back to factory defaults and I get green led's when I plug it in. I have it connected to a pc r...
Hello,My old link to the 7920 firmware doesn't work anymore. This is what I had: http://www.cisco.com/cgi-bin/tablebuild.pl/ip-7900ser-crypto Does anyone have the updated link?With Regards,Aaron McQuaid
Hello,I have a Callmanager 3.3(3) system set up in a seniors home and some of my residents are having trouble with dialing 9 to get outside dial tone. Is there any way I can use dialing transformations to enable them to dial out to the pstn without h...
Hello,I have Callmanager 3.3(3) running with pstn access provided with a fractional PRI being terminated on a VG200. This system is running in a community care facility and as clients come and go they want to transfer their old numbers in and out of ...
Hello Chris,The limitation that you mentioned is indeed a product of how the ASA is coded. You can't access the management interface of the IPS module from the inside interface of the ASA unless it is on the same subnet as the inside interface. This ...
What may be going on here is that the .105 address is falling within the 70.x.x.96/28 range. Try using a global address that falls outside this range for your static or use a /29 on the global and make sure that the ranges don't overlap.
I think you need to find out who is really sending the reset. You can do this by using the capture feature on the firewall. http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/cmd_ref/c1_711.htm#wp2025431
You can use a combination of static arp entries and arp inspection to accomplish this. You will need to statically define every host with the arp command:http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/cmd_ref/a2_711.htm#wp14795...
