Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a problem when I created a tunnel between 2 routersRouter Ainterface Tunnel1description ## TUNEL VPN #ip address 172.20.1.2 255.255.255.252tunnel source GigabitEthernet1/0tunnel destination 190.10.8.13------------------------------------------...
Dears.I have a router 7606-S and I need doing QinQ, but I can´t It.in my router:R7606-01(config-subif)#encapsulation dot1Q 10 ? native Make this as native vlan <cr>the command encapsulation dot1Q 10 second-dot1q 200, there isn't in my router. I ...
I have a router_A with a public ip for example 190.84.22.11 and other router, this router_B is connected to a modem (public IP for example 190.80.90.11 y LAN = 192.168.1.2, the modem is doing NAT).The router_B have the IP address 192.168.1.2 and I ca...
Hola,Quisiera saber si el WLC5508 puede administrar los modelos de Access Point AP1131, AP1252 y AP1262. Y tambien si los modelos de AP1262 son como los anteriores que se puede modificar su funcionamiento cargando un software para que trabajen como A...
Hello,I have a problem, I can generate reports with SCA Reporter, because I get the following error (image attached):I try to run the following script, but I can not:[CM-MSO1 scmscm @ bin] $. / jselect-sce-tz.sh - offset =- 300DURING THE FOLLOWING pr...
DearI have a Router_A with a IP address = 190.108.84.138 and Router_B is connect a Modem With IP WAN = 190.40.61.120 and IP LAN = 192.168.1.1/24 and behind is a Router_B with IP WAN = 192.168.1.2/24.I can do a ping form Router_B to Router_A because m...
Hi,I have a problem when I send the translations to a Syslog server, my router ASR1006 processing is elevated and becomes very slow, the average traffic of 700 Mbps, I wonder if with the Netflow will solve this problem.RegardsRicardo
