Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We are trying to set up a MTP to transcode media from ipv4 to ipv6 or biceversa. We are using a cisco ISR router Cisco CISCO3925, with firmware c3900-universalk9-mz.SPA.155-2.T1.bin. The thing is that the solution it works but just for a while, af...
Hi all,I have a question and I am quite lost, not sure if this is a possible thing to do. My idea is to create a site to site VPN between two routers at home (one in my workplace home and the other in my holidays/mum home), the edge internet routers/...
Hi people, here again ,I am having a problem with the traffic from the inside network to outside network, traffic is being dropped I don't know why or how to fix it. My set up is a s follow:in the outside network there is a router directly connected ...
Hi,I went through similar posts to this one but I didn't find the answer I am looking for. I'll explain what I am trying to do:I have a DMZ (50) from where I need to allow some protocols to inside zone (level 0). I am doing that with ACL, but after h...
Hi Blau grana and Jouni,your right, too many time configuring and unconfiguring the box, I miss to add the route in the ASA, is working fine now.Thanks for your time,Juan
Your were right, with real pings traffic seems to be filtered properly, just the packet tracer only showed one direction, not the come back. Thanks,Juan
Hi Jouni thanks for quick reply,That was my initial thought, I am new in the ASA world, so my impression was that ACL was evaluated first, then if traffic is allowed the inspection takes place, but as said that is what I did and what confused me:insi...
Hi Mohit,I have a doubt here as I am configuring an ASA at the moment. The very basic configuration comes with filters from less security level to higher security level interfaces. only traffic from higher security level to lower security inspected ...
Yes, sorry my inside zone is 100, and before adding an ACL in the DMZ traffic was flowing as expected, but just one ACL messed it all, I was using ASDM and the implicit rule from higher level to lower one disapeared to just keeping the ACL. Honestly ...
