Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I have a question about ASAs in transparent mode with 9.1 software version.I have read that in the newer versions in transparent mode, you have to configure interfaces to belong to a bridge-group. Each bridge-group behaves independently fro...
Hello,We are making trials with all the load-balancing methods that GLBP and we are focusing when no load-balancing option is configured and as it says here it should work as HSRP:http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6554/ps66...
Hello all,We are having problems with ospf adjacency on a cisco 1900 router. The problem is the following:We have mora than 70 lines conected to a central router and only one is having adjancecy problems. At firts we thougth it was because of the mtu...
Hi all,We have a router with two interfaces connected to the sames ISPs router, running BGP in both interfaces: Serial0/0/0:0 10.11.8.106 YES NVRAM down down ATM0/1/0.1 ...
Hello all,We are having a cosmetic problem with a etherchannel connecting 2 Cisco 6500, via 2 gigabit interfaces in each side. The link is okay and is it working fine, is more a cosmetic problem. The devices are directly connected and when we do a "s...
Hi,It is router 2 (the one thta should be as standby) hat we reload or disconect, and when it goes up it becomes the active for 5-10 minutes,We have tested router 1 as 887 and router 2 as a 1921
Hi Reza,Thank for your response, what you are telling is what I thought I should work, but we have tested several times the following:Working normal, router 1 is active one.Reloading router 2, when it goes up Router 1 becomes standby and Router 2 is ...
Hello M.I,Here you have the outputs you asked for:Remote: sh ip ospf int xx int xx is up, line protocol is up Internet Address IP, Area area_number Process ID id_number, Router ID IP, Network Type POINT_TO_POINT, Cost: 500 Topology-MTID Cost ...
Hi Mahesh,We are gpoing to try to do what you are saying.Tha ospf configuration is the following:sh run int tu1116Building configuration...Current configuration : 323 bytes!interface Xdescription Central Router 2Mbps(E)bandwidth 2000ip address IP wi...
