Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have attempted to create the VSS VSL between two Sup-720-10GB using OneX modules in the sups and passive TwinAx. This fails. Neither switch detects a peer and the VSL remains down. I have also attempted using 10GB-SR optics in the OneX modules...
"I have been rolling out Autodeploy to provision vSphere 5.0 U1 hosts in our environment. We are running on Cisco UCS blades with full 10GbE connectivity within our datacenter fabric. Our DHCP, DNS, TFTP and vCenter servers are all reachable over t...
Can anyone confirm whether VM-FEX / distributed vSwitch is supported on UCS B200 M2/3 running under vSphere 5.0 U1 (build 702118 or 623860)? I am getting mixed information. My local Cisco SE told me Cisco had revoked support for U1 until a new driv...
I am trying to connect a Nexus 5548UP to a Catalyst 4900M using Twinax. On the 4900M I am using a OneX converter (CVR-X2-SFP10G) to provide me with the necessary SFP+ port. I am using a 3m Twinax for the link (SFP-H10GB-CU3M=)The 4900M recognizes t...
I am planning the upgrade for our 6120XP FIs to be replaced with 6248s. I have the read the upgrade guide and need a little clarification. In our 6120s we are utilizing the N10-E0060 FC expansion slot for storage connectivity. We are not utilizin...
Padma,The M2s are using the Palo/M81KR CNA. The M3s are using the 1240 LOM. Both experience the problem. The bug toolkit refers to the Palo experiencing problems. Is it also to be expected with the 1240?Thanks!
The documentation in the link you sent states that V02 or higher cables are required. We are using V03. However, the document also says we must be at 12.2(53)SG1 and I realized we are at 12.2(53)SG. Thanks for sending this link!
Thanks Christopher and Jeremy. Just to confirm: I follow the upgrade process, swapping out the subordinate 6120 for the 6248, conencting the L1/L2 HA cabling and M1 port, power it up and configure it as the subordinate interconnect in the cluster a...
Jeremy,One further question to your setup: which (if any) of the six vNICs presented to ESX would you run in passthrough mode, assuming you are running vSphere 5?Thanks!
