Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI am trying to use mrtg to graph my current calls on my Cisco 3640. However I am having difficulty with OID #s.Refering to cisco page http://www.cisco.com/univercd/cc/td/doc/cisintwk/intsolns/dialsol/nmssol/mrtg.htm#31188I'm trying to use 1.3.6...
The simple answer is, yes. A couple of variables need to be addressed when using VoIP behind NAT. First and foremost what protocol of VoIP are you using H.323 or SIP? If you use SIP then NAT is not a problem. SIP was designed with NAT in mind and s...
The difference between them is, one provides Dial tone (FXS) and one requires Dial tone (FXO).In the simplest sense you connect a "regular phone" to the FXS card and a "phone line" to the FXO card.To use them in the 2600 you need an NM-2V or NM-1V
Hi There,Thank you for your fast reply, I tried 1.3.6.1.4.1.9.9.47.1.1.6.0 and still returned a value of 0.I have a cisco 3640, with an NM-HDV2T1-48, located in slot 1, my Channelized T1s are 1/0 and 1/1I need to see how many voice calls are up at an...
