Hello,I have set up an internal switch in a cisco 4331 router with an internal connection with BDI interface on the router and interface vlan 20 on the switch module.I have configured both interfaces with an ip address each within the same subnet. Pi...
Hi all,scenario: Two redundant CPE routers with one WAN link each to redundant PE routers. The LAN-IFs of the CPE routers are connected to a single User VLAN with only one IP Subnet. To speed up the routing failover BFD should be used. Can we use GLB...
For a customer we need to configure a couple of Aironet 1240AG Access Points for Bonjour/Apple Printing. I have seen some documents on cisco.com how to configure this (enabling multicast) on a controller. Unfortunately the customer does not own a co...
In a customer network I tried to create multiple VPN tunnels between two sites with one router at each site.At site A the router has two interfaces to two different ISPs with a static public ip address for each interface.At site B the router has two ...
Hi Scott,I have red the post you mentioned. But as far as I understood, the whole scenario in the post is based on a setup with a WLC (correct me if I am wrong).Our customer does not have any WLC (Controller).Best regards,Martin.
Hi Scott,does that mean that I have to configure some IGMP on the switches? In case that is the fact: No further configuration on the APs is neccessary?Best regards,Martin.
Hi Smitesh,here my understanding so far: When I create a lookback interface with a public ip address assigned by provider 1, this ip address will be routed from the internet to provider 1 because it is a subnet of the network of provider 1. When m...
Hi Smitesh,Thanks for your answer.Sounds easy. But for that solution I need public ip addresses on the loopback interfaces of each router (site), don't I?Actually all 4 interfaces are connected to 4 different ISPs - means (correct me if I am wrong) t...
