01-16-2002 09:00 AM - edited 03-12-2019 02:03 PM
Hello
I am trying to use mrtg to graph my current calls on my Cisco 3640. However I am having difficulty with OID #s.
Refering to cisco page http://www.cisco.com/univercd/cc/td/doc/cisintwk/intsolns/dialsol/nmssol/mrtg.htm#31188
I'm trying to use 1.3.6.1.4.1.9.10.19.1.1.4, to measure active calls, and it keeps returning a 0 value even though I see calls on the router.
I'm using it to measure calls off an as5300 and it works fine.
Is this the right OID? Is there an instance other than 0 to use?
Thanks
Lawrence
01-16-2002 10:21 AM
here is what i am using on my 3640
Target[Modem_Useage]: 1.3.6.1.4.1.9.9.47.1.1.6.0&1.3.6.1.4.1.9.9.47.1.1.6.0:public@ip_address
MaxBytes[Modem_Useage]: 24
Title[Modem_Useage]: 3640NAS
PageTop[Modem_Useage]: Modem Utilization on 3640NAS
YLegend[Modem_Useage]: Modem Utilization
Options[Modem_Useage]: gauge, nopercent, unknaszero
ShortLegend[Modem_Useage]: Modems
Legend1[Modem_Useage]: Modem Utilization
Legend2[Modem_Useage]: .
Legend3[Modem_Useage]: Max value per interval on graph
Legend4[Modem_Useage]: .
LegendI[Modem_Useage]: Utilization:
LegendO[Modem_Useage]: .
Colours[Modem_Useage]: GREEN#00eb0c,BLUE#0000ff,GRAY#AAAAAA,VIOLET#ff00ff
WithPeak[Modem_Useage]: ymw
01-16-2002 11:06 AM
Hi There,
Thank you for your fast reply, I tried 1.3.6.1.4.1.9.9.47.1.1.6.0 and still returned a value of 0.
I have a cisco 3640, with an NM-HDV2T1-48, located in slot 1, my Channelized T1s are 1/0 and 1/1
I need to see how many voice calls are up at any given time.
Thanks again,
L
02-24-2002 11:17 AM
Read the definition of .1.3.6.1.4.1.9.9.47.1.1.6
carefully first. It will not give you the number of active voice calls currently in place. It gives the current state of the modems like connected, offHook etc.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide