Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am very interested to pursue my carrier to SDN, I am good with Perl and PHP but I am not sure this languages useful for SDN. some say TCL or Phyton. is there any one can advice me or direct me a good source to look at it. thanks.
I am interested to get UT for ip-phone, I have Avaya Call manager and Avaya Ip-phones, is that can be done? or the call manager should be CCM (cisco call manager) to get the detail information on UT? if that can be doen what's the first step should I...
is that possible to remove DFM and IPM from LMS 3.2 I have never used and LMS appears to be slow and i am thinking trimming some unwanted apps may help. thanks.
I have multiple 6509 vss switch. and i notice when the standby chassis reboot I didn't get any snmp trap, but I got when the active one reboot. my question is is there any mib out there for detecting and got a trap when standby reboot? thanks.
I have added "snmp-server enable traps config" to my snmp configuration, other traps including snmp-server system-shutdown snmp-server enable traps snmp linkdown linkup coldstart warmstart are working just fine. but when configuration change I didn'...
thanks for the response. yes I have the following commands on my config. snmp-server enable traps vswitch vsl so that only work for dual active or both the active and the standby failed.. as I said I am looking for for theses 2 Active Supervisor E...
thanks for info. I have folow up question, we have HUM and we don't use it but the process keep running and some jobs automatically and that took unnecessary disk space,I am wondering if I can disable HUM.
thanks so much for detail answer. I need this output to create CMDB file which suppose to be on csv. but the point you mentioned like speed result with 9.535.. something like that didn't work for me. let me see other option if I can find. appreciated...
Thanks Martin, works great..my last question is, I want to run the command from remote server and the out put file to be written on that server instead of CW server. is that possible!? for UT cli I did by using private key without password /usr/...
