Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When using a client card set-up with WPA and being authenticated by an EAP-TLS server do you need to set-up anything between the AP1200 and the server. I have set-up a LEAP server and you need a shared secret etc. but i cant tell from the configurati...
Am i right in assuming that when using LEAP that the client set-up comprises setting the SSID and enabling LEAP?Do you need to set the Broadcast WEP key in the Client?If you do not have to set the WEP in the client i guess this means there is at some...
I am not sure if you can change the channel set yourself. It varies from manufacturer to manufacturer. Cisco you cant change it yourself. I am not sure with Intel
Hi Jason,i found when using EAP-TLS in the scenario you have mentioned the only way i could get it to work was by turning Network EAP on (in Access Point settings) as well as require EAP and Open. I also found that i needed WIN XP service pack 1a bef...
Cheers Eric i appreciate yor response.I think i'm nearly there now.I have enabled EAP-TLS on my win2Kpro client with certificates etc. and i am using the latest ACU (version 6.2) Access Point is set-up to do EAP (BUT NOT LEAP) but i cannot authentica...
Maximum output power on the 350 is 50mW (17dBm) however it is normal to use antennas of approximately 2-3dB gain which then takes you up to maximum isotropic output power of 100mW (20dBm). (17 + 3 =20dBm).
