Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All IOS commands entered in the switch take 18 seconds to process. I noticed that the following command tacacs-server dns-alias-lookup was enabled. Disabling this command allows the switch to process the IOS commands without any delay.I can't find ...
When using AnyConnect version 2.5.3054, the client fails to connect to an ASA that has either one of the following versions of CSD installed - 3.6.185, 3.6.1001 and 3.6.3002. The endpoint assessment fails. A pop up window appears...Posture Assessment...
Is anyone running 8.4.2? If so, have you seen any issues with this version? I have been testing this code in my lab for the past four weeks and haven't seen any issues that would prevent me from upgrading my production ASA active/standby pair but w...
Has anyone experienced a non-responsive issue with their ASA version 8.4.2 code? I loaded this code on my beta ASA last week and have seen it "hang" twice since the upgrade. The previous versions of 8.3 and 8.4 code on this same ASA did not have th...
Due to the recent security issue with AnyConnect 2.5.2019, the ASA pushed AnyConnect 2.5.3041 to the all of the Windows and Mac computers. After the upgrade, some of the Mac OS X computers can't establish a VPN session when using the new client. Down...
Hi Mohammad,I was unable to SSH or ASDM to the ASA. At that same time, my remote VPN users could not connect via AnyConnect and clientless (browser based). I could not get console access so I asked one of my co-workers located in a remote bldg to ...
Thanks so much Anisha for the response. I have used RADIUS (ACS 4 and 5) to authenticate to Microsoft AD or RSA Token Servers in the past so I am new to LDAP. This customer doesn't have a RADIUS server.
Hi Andrew,Just to clarify. Are you saying that LAN failover using a redundant interface without a switch or hub is supported in 8.0(4) or later software? I have tested both scenarios shown above in my lab using a pair of 5550's with software version ...
