Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.When trying to access the asa (8.0(3)) with asdm the console send follwing error message:vPif_isVpifNumValid: pifNum out of range!vPif_getVpif: bad vPifNum(0xa6) from 87EBC81 from 83833B4Have a strong suspicion that it is a hardware failure (si...
Is there a way of parsing syslogs from a context to the Management context ??(to avoid establishÃng L3 connectivity to each context, NB! The asa is running Transparent). This because transparent mode doesn't support shared interface (as it could hav...
As stated (by cisco) g.711 requires 80kbps.But why do I see 85kbps for 1 call on my policy-map (please see output/config below); what is using the (rest) 5kbps ?Class-map: VOIP-EF (match-any) 5 minute offered rate 85000 bpsMatch: protocol rtp au...
Thanks, but still according to Cisco doc. it should be possible to connect the 888 over an ADSL, but what is the difference ? (I know that the 877 work over our public ADSL but will the 888 work as well??) :http://www.cisco.com/en/US/docs/routers/acc...
