Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,
Im not up to much on the QOS side and we are changing all our old Cisco edge switches for a new vendor. I have a policy map that do not seem to be applied to anything, also a class map that doesn't seem to do anything either just wanted ...
Hi,
We have an issue where a group of servers are configured across multiple serverfarms, we are using least connections Algo and we would like to know if the Cisco ACE takes the total number of connections on a per rserver basis, or is it just pe...
Hi everyone.. I have a situation where a customer is moving from a legacy F5 to Cisco ?? Anyway the web site uses only http and the rservers only listen on 80 also. but the customer wants to have the URL re-directed or re-written so for example:...
Hi all I am using a FWSM firewall and have set up a Dynamic policy to PAT a /8 network into a /30 network... Problem I see is that the PAT is only using the first address in the pool for mulitple connections , I need it to use all 4 availa...
So in a nutshell..
The L2 QOS is enabled and active. the Policy map and class maps are redundant, this makes sense as its only an L2 switch.
The environment has many legacy issues, so when we move onto the new vendor only L2 QOS will be required...
its a 2960X
@Mark Malone wrote:what platform are you taking that extract from ?
This is the MLS QOS configuration
mls qos map policed-dscp 0 10 16 18 24 26 to 8mls qos map cos-dscp 0 8 16 24 32 46 48 56mls qos srr-queue output cos-map queue 1 t...
Thanks for swift reply, I thought that myself.. it looks like mls qos is turned on, but only the uplinks from the switch are using DSCP based on the default map. all other ports don't trust anything except cisco phones where they are configured. ...
I cannot believe that nobody else has this issue!!, I have two 6500's that hold the source ports, and a nexus 3524 that has the destination port to the collector. if the nexus wont support RSPAN I cannot see how else it could work ???
These swit...
So the issue I have is that we use an RSPAN vlan for monitoring upstream of the Nexus, and this will be trunked down to the 3548 where the collector is plugged in so we can use 10Gb. it was my belief that the RSPAN vlan needs to be created on the s...
