Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I'm seeting up a brand new, out of the box 5516x, i've followed every step of the configuration guide, configured the module in the same subnet and VLAN as the inside, but when loading asdm, which seems to take forever, it shows the firepower...
The following configuration appears to be correct , but when it comes down to incrementing the value when crc errors occur, it does not. There might be some problem with syntax, however I can't seem to find out where it is:event manager environment A...
That tool is for people that have not yet reached ccnp voice certification. Stop fooling everyone! Cisco shpuld place a notice on it, saying: just for uncertified persons!!!
You can not still possess a validade ccvp, you must already have a ccnp voice by now, since the first one as been retired for quite a few years. If you're ccnp voice, "just" pass ciptv2, and you will be ccnp collaboration. But be warned, it is one of...
OK, another stupid java error without any Info reported on cisco documentation . The latest java you can use is 8 update 51 and it has to be 32 bits. Tried everything from 2009 till now, and it is the most recent one that works. Damn you java, shame ...
Attached are the outputs from the asdm and the config. A I stated earlier, both management and inside interfaces are connected on the same VLAN and subnet, both addresses reachable
