Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We run a num ber of Catalyst 3560x switches with IP advanced services...They are currently set for sdm-prefer routing which gives 8K a possible IPv4 routes, howvere the switch has about 2400 routes in the routing table..We are about to enable IPv6 on...
We have a ME6524 running as a MPLS P router. We want to mirror a port to capture a specific traffic stream (to a probe). As the port is an MPLS LDP port will this work, will both the VACL and SPAN work with MPLS tagged packets, or does the mirror and...
Hi We have implemented a number of L2TPV3 tunnels to backhaul some wireless links, our customer would like to run rapid spanning tree over the link as there is potentially a loop, however it seems that the BPDUs are not being sent over the link... Po...
I have a strange situation on a clients PIX firewall. We are connected to a partner (via our outside interface) and the partner now wishes to use the internet via our network for just a number of devices in a shared DMZ (i.e. the internet is now resi...
Hi,I have a small enterprise customer, who wants to possible deploy MPLS to support a number of user groups. Unfortunatly there current network is a mesh of rings between POPs. My question is do I need to deploy a P and PE router in each POP, or can ...
Sorry for the delay, just seen your additional question. The external port can be used to setup Extranet access to say a 3rd party, ie. can be used as an additional public interface.
The position of both public and private interfaces is debatable. I have implimented a number for different customers and installed both with the outside interface directly on the outside of the firewall and in a DMZ, also with the inside interface on...
No this is not possible with replication, replication will overwrite the data base (for the desired replication component) on the secondary server.You may have no option but to do it with csutil, but you may want to read up on the encrypted password ...
