Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am upgrading a Cisco 3750 to 3850 and running into issues with some MLS to MQC conversions. Would anyone know how I can convert these three command lines within an interface interface GigabitEthernetx/y/z srr-queue bandwidth share 1 70 25 5 srr...
Hi,I am after the "send log <LINE>" command that you can use on the Cisco IOS device to test that the syslog is receiving the logs for my Nexus device.
Hi,Does anyone know the reason why I cannot type any commands via console on the AP. I have tried rebooting it several times and even powered it via power only and no interface connected but still no luck.
Yes I have tried from 3 different laptopsBaud rate: 9600Data bits: 8Parity: NoneStop bits: 1Flow Control: RTS/CTSThese are just the standard I have for all my Cisco Devices
