Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,
we have a topology where the Multicast traffic is originated from a network which is not directly connected to the PIM DR (the sources are located on a network which is routed through the ISP Router). In this scenario we see that the DR is ...
Dear all
i would try to grant a RADIUS user SNMPv3 access privileges.
The remote user (ciscoprime) is able to connect through CLI and he gets the role (network-operator) through the AuthZ provided by RADIUS but when I try to use SNMP v3 authenticatio...
Dear all
We suspect that there is a misconfiguration on our voice gateway (CUBE) or on CUCM10.5Basically this is what we experience:1. SCCP Phone calls an external number
2. call is established, no problems3. The internal phone is shu...
Dear all,
we have CUCM10.5 with CUBE and we setup the Calling party selection on the trunk to show the originator.
So, for example,
- user with extension 1234 and external mask +31444xxxx forwards all the calls to mobile number 06-666-9999
- internal...
Dear all,
in our Campus network we have a working multicast implementation with IGMP/PIM sparse mode.
The clients are able to receive multicast streams, but when we connect the client to the network through a Phone (on the same Switch port), both the...
As workaround we fixed the issue by assigning a secondary IP address on the same range of the remote network, at that point the DR started sending the REgister message to the RP.
Dear all,
we contacted Cisco TAC and we were able to fix the issue by applying these settings:
ip rtcp report interval 5000
gateway
media-inactivity-criteria all
timer receive-rtcp 6
we are not using RTCP and with these settings the "ghost" calls ar...
hi Mohammed,
thanks for your message. I tried these settings:
ip rtcp report interval 1000 gateway media-inactivity-criteria rtp timer receive-rtp 180
but the call stays UP. I tried with different timeouts, but the call is not shutted down.We opened...
hi mohammed, thanks for your message. i will test it tomorrow morning from my phone, but enabling it in production would require changing the Device pool of all endpoints (and restart them). We are also involving the support contract to check if ther...
Dear Mohammed,
i tested it but unfortunately using this setting the gateway drops ALL the calls that are longer than the receive-rtcp. Maybe the "silence detection" can be tweaked?
thanks
s
