Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I maybe over thinking this but I have an ACL that is applied inbound on an interface vlan. I have a line to permit udp any any log which is temporary. I see hits but the source ip is off network to destination interface vlan ip address. I expect ...
Hi, I have an issue were thousands of connections on the ASA are marked with flags E, below is a visual of the connection. Any ideas what could cause this marking? Also, I can't grasp what the meaing of an outside back connection (ie flags E). Thanks...
Hi, I was wondering if there is a way to remove a redistributed default route from a branch router’s routing table automatically, when one router goes down. Example: R1 and R2 redistrubte a default route 0.0.0.0 to R3. If R1 goes down that default ro...
Hi, I was wondering what could be a cause for the input queue drops and flushes number to be the same. If you have any commands I can run to do some troubleshooting that would be great. ThanksFull-duplex, 1000Mb/s, media type is SX input flow-contro...
Hi, I am trying to setup a simple html website to take a rserver in and out of service using the built in ACE module xml api. What would be the html code to post the xml command using a button? Currently I receive <error err_num='103' err_str='XML_E...
Hi, I have the same tablet with the same issue, disabling the OV8830 sensor does the trick. Also all video calls made with the tablet using Jabber Video have greenish hue.
