Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Sorry if my question is quite basic, but how can I check the current DHCP leases under CallManager 5.1? I have a suspicion I have exhausted one scope.Thanks in advance,Paul
Dear all,Just a quick question concerning the CSS for BLF presence.Phones are 7961 SCCP.CallManager 5.1I have 2 DNs in 2 partitions1001 partition_11001 partition_2My presence CSS is;CSS_TESTpartition_1partition_2I add a BLF for 1001 in partition_2My ...
Generally you should trust/mark at the edge. If you have Cisco phones they are already marking traffic, therefore just trust these access ports. If you have a strong global policy and have marked/trusted at all you access switches, you can go ahead...
Your question is very broad and thus varies by platform.Most new Cats have ingress queuing and egress queueing. For lower end switches this can normally be found in the data sheet for each device. For chassis switches it is usually dependant on the...
You can also use the mrm tool in IOS to test multicast flows;http://www.cisco.com/en/US/docs/ios/ipmulti/configuration/guide/imc_routing_monitor_ps6441_TSD_Products_Configuration_Guide_Chapter.htmlBy the way Kevin, nice to see the CCIE behind your na...
Perhaps you mean Carrier supporting Carrier? This is whereby an ISP has geographically disparate sites and uses another ISP to interconnect them. Here there is a hierarchy of VPNs whereby one ISP has end VPN customers but is in itself an end VPN cu...
Perhaps you could use some form of object tracking?http://www.cisco.com/en/US/docs/ios/12_4/dial/configuration/guide/hdbackup.html#wp1057186I have not tested this, but maybe you could track your interfaces and when they go down the static route shoud...
