Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, We have ip cameras on a SG300-28PP switch, and one camera sometimes stop to working for a random amount of time (1/2day-2day).After, something happens and this camera starts and working fine for a while. On the corresponding switch port i see...
Dear Support, Please give me deatiled information about the "active clients per cluster" parameter of a WAP321 AP. Datasheet says active clients per cluster = 80, but i find a presentation where this number is 160 (attached). ???Another question is...
Hello guys!I want to connect 2 site's LAN with wireless, but no clear line of sight.so i have to implement one more device on a building between the 2 sites.Users on the remote site (3.) have to reach resources on the 1. site.1.and 3. outdoor access ...
Hi all,My question and problem is the following:In our network there are vlans and in the windows explorer we want to browse all the PCs and access the shares in the whole microsoft windows network.We have a 3550 switch for routing etc. Within the vl...
Hello!My question is the following:If i set up a pptp vpn between a Cisco rv082 router and a microsoft client,Can i set the client idle timeout someway? or Have a default value pre-configured for this?Because this device support 5 users to connect at...
Well, I will be sure to test this setting too.And on next week we replace the faulty camera with a new one, and i will test with the faulty one and an another sg300 in lab environment.And debug the negotiation phase with a C2960 for example to see wh...
Sorry Dan,My last information was incorrect, because on this switch we haveonly 6 pcs of 73048 cameras with max 8,04W power consumption,and 18 pcs of 93024 cameras with 4,44W max power consumption, so it is 129W total. But if the switch allocate the ...
Yes!And here would help the debug function, but no documentation about it.or how to use this debug-mode, because it is not the traditional Cisco debug. I tried to look at some command in debug-mode's help, but couldt find any poe related. So if anybo...
Dan,There are cameras on all 24 ports. But the overall pover consumption was 70% at night,when IR leds are active and the cameras use the max power.I attached the datasheets of these devices and the outputs the 'sh pow in' commands. Thanks, Zoltan.
Thanks Dan! First i will do an firmware upgrade, because i found that the actual image is not the latest.And fortunately i can go to this customer with a new camera on next week, and i will do these tests. I will post here the results.Another interes...
