Hi,I have a pair of Catalyst 6500 switches and another pair of Nexus 7000 Switches. Catalyst 6500 has few set of vlans for which it's a spanning-tree root bridge and HSRP active/standby for those vlans. Nexus has few set of vlans for which it's a spa...
Hi,I have a pair of Catalyst 6500 Switch which supports Layer 2 and Layer 3 functionality. We have SVI created for vlans let's say vlan 4, vlan 5 on these 6500 Switches. Now i want to migrate these SVI over to Nexus 7K Switch.Please note the Catalyst...
I have a 2 Nexus 5k's in a VPC environment. These 2 N5K's connect to the 2 upstream Catalyst 6500. Right now the the port-channels connecting from Nexus 5K's to Catalyst 6500 are enabled with jumbo frames(mtu 9216). As a part of migration work, i am...
I have a nexus 7000 with two Supervisor engines. One is Active and the other one is Hot-Standby. I have connected the management ports from each supervisor engines to Catalyst 3750 Switch. The management connections MGMT0 (copper connections) comi...
Does Nexus 6000 supports OSPF without L3 Daughter card ?? Seems like i don't have L3 daughter card, so can i enable the OSPF Switch1# sh invNAME: "Chassis", DESCR: "Nexus 6001 Chassis"PID: N6K-C6001-64P , VID: V01 , NAME: "Module 1", DESCR: "No...
Hi Bilal, I understand what you are saying but SVI for vlan 4 already exists on N7K which already has few secondary ip addresses so i don't want to make even bigger broadcast domain by adding another secondary ip address. Thanks
But when i do.... "sh run int po1 all" i don't see mtu 9216 config over there. In my case, Port-channel 1 is a peer links between Nexus 7K. Could you please let me know how can i verify jumbo frames has been enabled on the peer link.
I didn't see that symptom and thats' where my concern is:Cat4500# reload System configuration has been modified. Save? [yes/no]: n when i put reload the switch will reload without asking me to save the config.Thanks
I rebooted the switch using "reload" command. But still the switch comes online with the original config. The strange thing is when i put the reload command, it doesnot ask me to save the config as other switch(Catalyst 6500,3750) does.Thanks