Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I run jabber on my Windows, when I login, it prompted a waring message"Cisco Jabber can not accept the certificate file".
I tried to uninstall Jabber and erase the folder related to Cisco Jabber, but it still does not work, is there anybody met this ...
I run jabber on my Windows, when I login, it prompted a waring message"Cisco Jabber can not accept the certificate file".I tried to uninstall Jabber and erase the folder related to Cisco Jabber, but it still does not work, is there anybody met this i...
We deployed a ASR1001 as a SBC to connect to PSTN, our SBC takes the inbound call from SIP provider via Trunk-A and transfer the call to an audio bridge via Trunk-B.
But, our SIP provider will send the SIP signal with Min-SE=90, we must setup the Min...
We have an ISR2921 working as a voice gateway, and we can connect to an ISP thru a SIP connection.
the SIP provider give us an username/password and SIP domain of SIP proxy server, how to use the user account to register to the SIP provider? how is t...
Hi Vivek,
I tried the command on a router, I can not type "session refresh" in min-se parameter, but "session-expire" instead, the value can be 90-86400.
Is it right?
Thanks Vivek for your comment.
further more, how to configure "session-refresh timer"? I cannot find the IOS command in the cube document, there is only min-se under config terminal, could you please post the exact command line?
Thank you very much!
Hi Ibrahim,In the Cisco official document it says version 8.5(1) or later, but I tried in cucm 8.5(1), there is no CP-8811 even 88xx series phones in the device list after I uploaded the ".sgn" firmware pack for 88xx.
