Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is AnyConnect supported from a Windows Embedded system? I have an HP Windows Embedded Standard laptop, and it looses all network connectivity after connecting to the AnyConnect VPN. The client loads and connects fine, but then the system loses connec...
I will be setting up a UC560/UC540 multi-site solution, and would like to know if anyone has setup multi-site with three digit extensions. The two sites currently have two digit extensions, i would like to make them three digit extensions and be able...
I'm trying to setup an ASA and a UC540 side by side, to utilize the ASA for data networking and the UC540 for voice. This 'should' work fine, I just seem to be having an issue where the ASA seems to be blocking traffic from the voice network as it pa...
I've been having an issue with a UC320 with FXO lines from Frontier in northern california. Complaints from the customer are low incoming audio, low outgoing audio, echo, and general poor audio quality. I have tested and set impedence on all lines, t...
I updated two systems to the new software today in hopes of resolving some issues i'm having, and ran into dial plan issues after doing so. I'm posting A) to get comment from the Cisco guys and B) as a warning to other users.Here are my experiences:...
Update, my issue appears to be a bit different. Everything works fine when on an untagged port on the switch in the guest VLAN, i am only having problems while connected to the guest SSID on a WAP321. It would appear that I have more of an access po...
I cannot ping anything from the guest subnet. The weird thing is that it appears I can do DNS NS lookups, but can't ping or browse. I can't even ping the guest gateway interface on the RV180, is that pingable for you? DHCP is working and is on the co...
Any updates on this issue? I think I am seeing the same problem. RV180, SG300 Switches, and WAP321s with two SSIDs and VLANs. Everything works fine on VLAN 1, but on the Guest VLAN I cannot access the internet. VLAN tagging and DHCP are all correct.
Great, sounds promising. Can you by any chance send me your H323 and dialpeer config for this? I was sure that Presense was going to be a pain (or not possible), thats good to hear that you have it working, can you send me that config also?Also a que...
