Hi all: Im using CNA and get that result when I try to add one SW. Apart from the obvious message, is there any possibility to solve it? Thanks W. ... View more

Hi all: We are having issues with CNA and some Cisco switches. All were discovered, but some of them are shown as neighbors (although they are part of the same discovered subnet). When we try to add them to the Community, it display a message: SW is not reachable Unable to Connect Any ideas? Regards ... View more

Hi all: Executing a Vulnerability Assessment in an ASA 5510, it has detected a "SSL / TLS Renegotiation Handshakes MiTM Plaintext Data Injection". As a recommendation, it suggest to contact the supplier to find any patch. As of now, we couldn't find any patch. Could you please help us? IOS ver is Cisco Adaptive Security Appliance Software Version 8.0(3)6 asa803-6-k8.bin Thanks ... View more

HI all: We have several switches PoE Cisco 3560 (cisco WS-C3560-48PS (PowerPC405) processor (revision Q0)  for our IP phones. We needed to migrate to a SSH enabled IOS (c3560-ipbase-mz.122-35.SE5) The IOS we got was: c3560-advipservicesk9-mz.122-46.SE.bin Then, we updated and we got problems with some switches as they were delivering 15,4 to all ports PoE ports, therefore, consuming all 370 W in less ports than available. That provoked that some phones were out of energy. As a workaround, we set power inline to 7 watts in all ports, but there should be another solution, right? Thanks in advance W. ... View more

Hi all: We have configured CNA and having problems with timezone shown on it for the devices. Some devices were configured: clock timezone UYT -3 clock summer-time UYST recurring first Sunday October 2:00 2 Sunday March 2:00 but in CNA is showing what is attached. Although it is the same offset (-3), it is not the same timezone as Buenos Aires does not handle DST, and in CNA appears as disabled (and also does not allow to configure recurring option) Is there any way to solve this as we need to configure all our devices with above commands? Thanks Regards ... View more

Hi all: We have a big network and every time we need to execute commands in switches and routers, it takes a lot going one by one to do it. Is there any way, ie using special software, or Linux, scripts, whatever that can be used to execute same commands in all devices at the same time? Thanks in advance W. ... View more

Hi all: Could you please help me finding a Log Analyzer tool for Cisco devices (preferably, free). Thanks! W. ... View more

Hi all: I'm having problems with my CIPC 7.0.2. I was using it on my CCM, as usual, but then I needed to change it to another CCM for testing. I had to erase config from CIPC. Once I came back to my CCM, it registers, but it does not take all the configurations (for instance, does not show ringtones, backgrounds other than default one, Corporate Directory, etc.) I have uninstalled several times, delete all registry keys, but it is still happening!! As of now, I have uninstalled 7.0.2 and installed 2.1.4, and now I get a "host not found" everytime I click on "Services", "Directories", etc. Help? Regards ... View more