Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I've set up IOS XE Embedded Wireless Controller on a couple of 9120's. So far so good. Now I want to add a 2802 as subordinate AP. HOW? How do I get the correct image for the 2802 on to the AP? Do i upload something to the EWC or do i need to con...
We've just installed a couple of ASR1002HX in our network and want to manage them and run AVC in Prime 3.1. Seems the routers are not supported in Prime yet? Anyone knows about an ETA on a device-pack for ASR1002HX support?
Hi,We are migrating from a nother brand to an ASA Cluster running 8.4.5We have a web-server on an inside interface listening on a non standard port - 20111. We have created a static NAT translating the public ip to the private, so If I do http://publ...
I have an ASA5505 at home. Connected to a 10240/1280 DSL. I use a bit torrent client with a built-in scheduler set to connect to bit torrent-network at midnight and disconnect at 7 AM.Every morning my connection is dead.I can reach the asa with telne...
So, years old topic but.... I have the exact same problem. Did anyone ever find out what the problem is?I have a Palo fw and it's not possible to access the management gui through the firewall. I have tried to create a test-network with an svi and ac...
Thanks, I get what you are trying to say. Point taken. But - I'm trying to understand the basic concept. In traditional WLC, the AP always get software downloaded from the WLC. Yes, it can happen that some AP's have a "wrong/old" version/cert error s...
So what you are saying is that I have to upgrade the AP manually/tftp and it will automatically associate to the WLC? No need to install an ap-image on the WLC it self? This doesn't sound like a very scalable solution? What if I have a 100 AP's? Isn'...
We have tried to upgrade to 8.3.120 (from 8.0) two times on WISM2, crashes the controllers, confirmed bug from Cisco.
Also tried 8.3.120 on virtual WLC, and there is a problem with not all AP's registering (2802/3802 AP's).
Finally upgraded WISM2 ...
You need to specify networks that can access the pix.By default, http (what you need for asdm-access) is configured to allow access from 192.168.0.0/24 on the inside interface.If you change the inside-adress you would need to connect with console-cab...
