Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning,
We're looking at purchasing a 7604 or 7606 chassis and using S2T-10g-XL route processor and ws-x6908-10G-2TXL line card but I'm getting conflicting information online about whether the RP and line card are supported in the 7604 or 7606 ...
Hello,
I'm looking at several options for an edge router in a small to medium sized network. I've used ASR1001-x's and ASR1004's in the past and have been very happy with their stability and performance. However, I'm also looking at ASR9001 as thei...
Hi,
I have a question about what the best method to configure an MPLS network where there are two WAN links between sites. The intention of the second link is to be a backup and will be only used if the primary goes down. I don't want to use the ba...
HiI came across a strange issue today where a couple of ibgp sessions were stsying up for 3 minutes then dropping.I had recently changed the lan mtu from 1500 to 9000 and all was ok until the bgp sessins had to re-establish, then when they did they f...
Hi,
We have a situation where we have an ASR1002 that terminates DSL services and also forwards some onwards to other routers. Our requirement is to forward all sessions with realm @realm1.com to another router (routerB) and terminate all sessions w...
Thank you for the reply. Yes, I was aware the RP and the line card would work together, but I wasn't 100% sure about the chassis. Thanks for the clarification.
Jonno
Hi,No, I'm not using loopbacks on this iBGP session - here's the config I have applied. The ip ospf mtu-ignore is there so that OSPF stayed up while I messed around with the mtu sizes. Router_1 (7206 G2)interface GigabitEthernet0/2.700encapsulation ...
It looks like what I'm trying to achieve can not be done without the use of radius (unless anyone can advise otherwise). It seems the vpdn authen-before-forward command forces all auth to be sent to radius first.
Thanks Hector.
The default route isn't really required and one plan is to remove it and do as you mentioned with adding the management IP's. But since I don't redistribute statics at the moment, I wanted to get some opinions on what others are doin...