So i received the DNA Center Lab kit with the Appliance, ISE VM & 2-9300 Switches.. is there any topological documentation on how we should connect this?
The Docs i've seen strictly look like the DNA center appliance configuration. But i don't se...
I tried the upgrade to 16.6.1 and experienced the same behavior, however, after removing NAT from the outside interface and reapplying the SIP trunk Registered and connected..
in 16.6.1 the bug is still present with NAT using the SIP ports:
ga...
I currently have a ticket open for the same issue.. The bug is listed as CSCuy82008, So far TAC has mentioned the following solutions:
Reload the gateway with NAT disabled, and manually enable it, after the gateway finished bootingUse pool over...
Configuration for the 3560!!!enable ip routing on the 3560!ip routingsystem mtu routing 1500!! Note the IP's Listed here would need to be your Default Gateways on the Hosts!interface vlan 1 ip address 192.168.1.1 255.255.255.0!interface vlan 10ip add...
Its also worth noting your configuration would work with just enabling a routing protocol on the router like eigrp/rip etc.. jsut remove your static routes on the router & do something like this on the router.router eigrp 1network 192.168.1.0 networ...
Not sure what your trying to accomplish, If you have a 3550, that is a layer 3 switch, You can essentially do all of your routing from the switch and create a layer 3 link back to the router if necessary,Example Config for intervlan routing on lay...