Hello All, I have a situation where calls that are forwarde back out to the SIP PSTN are being rejected because the calling number is not recognized. 1). Phone A on PSTN calls Phone B which is on an Avaya CS1000M PBX.2). Cisco Voice Gateway ter...
Hello All, I am having trouble with outboud SIP PSTN calls through a Cisco 2911 Voice Gateway. 2911 VG terminates PSTN SIP Traffic and connects to Avaya CS1000M via QSIG PRI Trunks. When calls are attempted outbound fron the PBX the caller gets a...
Hello All, Can CUCM manipulate the Caller ID name that is presented to a called number when calling to the PSTN? If so is there good documentation on how to do it? Thanks!
Hello All, Does anyone know if there is a way to turn off the display on the 7921 when it is placed in the base. I have acustomer who has the phones throughout her home, including next to her bed. She would like to turn off the display without ...
Hello All, Does anyone know of a way to turn off the TSW on UC 560. I have an existing customer that was programmed via CLI and when trying to use the CCA the TSW wants to run before I can make Changes. Any Ideas. Thanks!Shawn
After trying translation rules I found that the translation rules were allowing the voice gateway to send calls back out to the SIP PSTN if both PRIs to the CS1000 were down, which is not desired by the SIP provider and caused other problems. Delvi...
Thank you for your reply Leonardo! I have tried voice translation rules and SIP Header modification. Because the redirected connection is H.323 to SIP there is no Diversion Header to modify, and if I modify the From header all calls will be a...
aokanlawon, I apologize for the delayed reply, however I had to wait for th provider to be available to test. Yes, This has been fixed using the method that you described above. I can now see the correct information in the SIP messages, as...
Thanks for the reply Alex! I Had the Provider SBC Address set as trusted (see capture below) and it does show up as trusted. In my original post you can see that the "from" address shows as 7026672375@74.4.9.21 when it should be 7026672375@. Coul...
