Hi,
I have two WLC 5508 controllers running in SSO HA Pair. The primary unit crashed and lost all config, license, and image files. The failover to secondary was successful and now it is running as secondary (active). The secondary unit is HA-SKU...
I have a WLC 5508 that I just setup and it is giving me this error:Warning: Controller has detected its IP Address 10.2.200.2 being used by a machine with MAC Address 50:57:a8:c6:e5:2fThe problem is that the conflicting MAC address is the one associa...
Hey all,I am in dire need of some help. I am currently trying to open my NAT for use with Xbox live. I have searched the forums and found great information but I cannot seem to get it to work for me. If I do not use any port forwarding rules at al...
Hey all,I cannot seem to get my config quite right. I want to open my NAT but I can only seem to get it to moderate. I think it has something to do with my ACL because I am pretty sure that I did all the port forwarding correctly. It must be a sma...
jr,I think you can follow my directions and swap the words primary and secondary. The outlined steps will be the same but you are performing most of them to the secondary/standby device instead of the primary/standby device as I did above.
Thank you. You were able to confirm the correct upgrade procedure when two Cisco TAC engineers could not. I perfomed the replacement following the steps in my original post. Here are my notes from the procedure: Update code on the replacement prim...
I did have lag enabled but I found my mistake thanks to this. I went back and read the guide again. I thought since I had my two switches together in a stack that I could split the port channel up for redundancy. All port channel members must belo...
I updated my config and I still cannot get this to work.... I know it has to be something I am missing. I included some more of the information that might be needed to troubleshoot this. Everything I can find on the net shows that I must be close...