Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,If I go into the Report Launch Pad, then I:Client / Client SessionsWith any report I generate, I run the job, then I get an error:"No data matches the specified criteria for the report.Make sure that the following poll jobs are running:1.Radio...
Hello everyone,We have recently installed a pair of Cisco AIR-CAP1532E-E-K9 APs forming a radio link to join our client's two buildings.Both are registered on a model 8540 controller with software version 8.10.183.0.The antennas are correctly oriente...
Hello everyone,Soon we will have to perform the firmware update to one of our 8540 WLC It is currently running with version 8.5.161.0 and has about 5500 APs registered. On previous occasions, we have managed to do it although we have observed behavio...
Hello everyone,My question is the following.In an environment with Cisco Lightweight APs (mix of 2802 and 9120) in Flexconnect mode under the supervision of a Cisco WLC (model 8540 with 8.10.183.0 version), who is in charge of roaming a client betwee...
Hi all,One of our clients has a WS-C4500X-16 switch. Due to connectivity needs, it was decided to install a network module (C4KX-NM-8) in the free slot. The module comes from another 4500 in operation and was removed 'hot swap' without pressing the O...
In relation to this topic, I have a mesh network with 2 AP AIR-CAP1532E-E-K9, one with the role of RAP and the other as MAP. We only work with SSIDs that use 802.1x. Clients connected to the LAN segment connected to the MAP report ongoing problems. I...
Thanks for your help @Rich R !The idea of using the 'FlexConnect AP Image Upgrade' functionality seems great because we have it activated in our environment!If I have not misunderstood the procedure, would you try to do the predownload for each of ...
