Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Recently i have insttalled several 1532e Aps with a controller 5508 version 8.0.121,
Only work the automatic priming with internal APs with 1532e the automatic primming not work. I tried to use Cisco air provision follow this proccess
http://w...
Hello
I have a controller 5508, with, internal antennas 2700 Series and external antenas. All APs work fine, internal APs have green led and when somebody connect turn to Blue.
But with the external antenas i have the led blinking green and red, I ch...
Hello,is there any way to manually change HA status on Secondary Prime 2 after initial setup?CLI commands does not have any option to add high availability configuration after being removed.Thanks.
You need to configure a routemap with policy routing to separate outgoing traffic and based on the destination port to take it out through your second gateway to the internet, missing data to give you a more concrete answer.
I have changed the AP to other switch with POE+ and enough free inline power and the problem persist.
in the AP log not show nothing rare, in the controller log the same, nothing rare.
This is the loading secuence
blinking green Cycling through RED...
i was looking and inline power is close to the limit of use.
Thanks for the Hint !! I Will solve it changin some aps to other switch with more free inline power.
You were right: I have applied "ncs ha remove" and configure again from GUI on Primary Server and now,CPI-01/admin# ncs ha status [State] Primary Active [Failover Type] automaticCPI-02/admin# ncs ha status [Server] CPI-01(192.168.1.5) [State] Seconda...
Hi Afroz,I thinks HA configuration from GUI can only be done from Primary Server.Trying to operate with second option "hasetting.xml", wich parameter do you mean do I need to modify?Here we have current config:ade # cat haSettings.xml ade #The proble...
