Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all So I'm more of a SP guy, but have the task of replacing our old trusty 6500's (sup720) and our IT dep. bought few 7706'es but as we run them as PE's into our SP network the task to configure them falls to me So I'm faced with configuring the...
Hi all
We have a NCS5501-SE in a edge configuration towards IX'es
We have been running microflow policing on 7600/RSP720 - and we need to apply this to the NCS .
match criteria should be /32 ip addresses to be capped to some reasonable value
I'...
Ok - I'm trying to get a egress policy to work on a NCS 5501-SE
Get this error, been reading the documentation- not quite sure what is going on.
NCS is on 6.2.25
Error:
RP/0/RP0/CPU0:XXX(config)#int te0/0/0/0
RP/0/RP0/CPU0:XXX(config-if)#servic...
Hi all
The setup I'm looking at is two BNG's running on ASR9010
We use them to aggregate all PPPoE and IPoE traffic from multiple locations using AC/Xconnect into a looped interface, so we get all traffic on one BE interface with multiple subinterf...
Hi all
I have trunks connected to wholesale providers, providing xDSL/FTTH etc and the users are delivered to us via L2 trunks tagged.
I have still 7600 SUP720's terminating those connections and bit stuck using that platform (remote locations)
So...
some pointers I have learned and are quite hard to find run daotmp_client -mgps-port-dumpmust be run through the console - not via VTY -else it just returns NULL default baud rate is 4800 baud and seems to be preferred clock-interface sync 2 loca...
Hi - thanks four your reply I have already played with the VDC config and it's quite clear to me. The question is more on the actual features and support of routing/LDP/MPLS/MP-BGP etc inside of the VDC - if there is any downside of using multiple VD...
Thanks for the reply
I was starting to suspect this, just wanted to be 100% sure I was not missing something before going to the alternative solution.
guess we hope for some other major fixes before they introduce this into the mix
Hi Aleksandar, thaks for the reply
One thing I don't quite understand is the GI address
As we deployed DHCP we use a Loopback with the GI address, the BE access interfaces use this Loopback as unnumbered IP and we can then use many BE access inte...
