Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2901 router and the flowcontrol is ON for both direction. Does anyone know how to disable it?Router#show interfaces gigabitEthernet 0/0GigabitEthernet0/0 is up, line protocol is up Hardware is CN Gigabit Ethernet, address is 8843.e160.7ae8...
I find that NM of CEoIP does not support E1 with AMI. I suppose CEoIP provide a transparent solution to T1/E1 over IP network. My project is to simulate a E1 tie-line between two location over IP WAN link. As it is not support E1 AMI, can I use the u...
I want to know more information about the assignment of mac-address on each L3 SVI. Is there any guideline and how to show the range as it is not unique MAC address.For example, if the MAC address of the ME3400 is 0000.0000.0001. What will be the MAC...
I am helping my customer to test the PPPoE solution. The requirement is that she like to have a PPPoE server (7200), enable the DHCP pool on the router. The PPPoE client (1811) should receive the IP address through the DHCP and with subnet mask (/24)...
I have a AP1200. AP1200 come with 2 RP-TNC connectors. One is "Right/Primary" and the other is "Left". I want to know which one is Tx or Rx. Can I install two directional antenna that one point to left and other point to right, in order to increase t...
Hi Vyto,Not yet but I plan to open a TAC case. I am now trying to setup a simplified environment in my lab for easy simulation. I have also enabled VLAN, OSPF on the PIX now. I will remove them and prepare to work with TAC.Cheers Vincent
Russ,Thanks your attention!FIrst of all, I initially configure the PBR on the interface vlan which join the OSPF network to control some of the traffic. At that time, the C3550 EMI prompt an error message something like "you should enable extended ro...
That means Sup2, PFC2 and DFC enabled line cards cannot increase the L2 performance to 210Mpps. Just remain to 30Mpps for L2/L3 switching. Am I correct?
