Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
It seems that I have a problerm with AP's connecting to the 5508 controllers. I use infoblox as my DHCP servers. I use option 43 my string is as follows. 0xF10C0A09F5050A09F5060A0CF505I have the primary/ Seconday and teriary controller listed.The que...
Hello all, I have multiple remote office locations and I have implemented HREAP using central authentication and local switching. The offices have 3 vlans. switch/router mngmnt, Wireless management and the office vlan. The access points are 3502I. Th...
I have an interesting problem. My connections to the guest wired access drop consistanly every 1 -2 minutes. There are no drops in the mobility between the WiSM and the 4402 anchor in the DMZ. DHCp is served from the 4402 DMZ controller as well as t...
Good monrng all.I have seen this not once but now twice in less than a week. I have several remote offices up on HREAP. The configs were done on the WiSM using 7.0.116.0 code. the configs were saved and the sup720 in the 6500 was upgraded and reboo...
Good morning to all, I have finished the preliminary work in our lab and I think I'm ready to deploy. However a coworker brought up an interesting point that I couldn't answer. I'm creating a small /29 scope on the state office router 192.168.1.0/29 ...
From what I had read it had to be 0C. I wanted to be sure. I did test with both 12 and 0C and neither seemed to work. With that said, is option 60 have to be used in the newer code or is that still optional or a requirement ? The way I read it in on...
Shawn, I went back and reviewed everything and everything was duplicated , Except... WLAN_ID. The Wlan ID tags were different. I created a test and failled my two test AP's and they both came up on the backup controller with the proper vlan ID. now I...
My setup is very similar to this. I'm running ver 7.0.230.0 code. I have the same problem. I loose the office vlan's on a failover from the primary to backup controller and gain in the other direction.
