Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi We have purchased "FS-VMW-10-SW-K9" for our Firepower Management Center virtual appliance.Two questionsThis means we are able to manage up to 10 Firepower Devices/Sensors?If we need to add device/sensor 11 and 12 would we need to purchase a separa...
HiI am currently facing issues with the DHCPRELAY Agent on the Cisco ASA (5555-X ,ASA 9.6) . We have the following deployment.Cisco AP -> Cat 3K -> Cat 6K -> ASA -> Windows DHCP ServerThe APs are not able to get DHCP and from the ASA I can only see D...
HiI have setup and configured tacacs on Cisco ISE 2.2 and have successfully migrated 70+ device (IOS,ASA,WLC) to tacacs+. I am now facing the following strange issue with a few newly added devices I am trying to add. The authentication status continu...
Hi Guys Just a quick confirmation question. We have a Cisco WS-C6509-E chassis switch with the following modulesWS-C6509-E#show module allMod Ports Card Type Model Serial No.--- ...
More Debug output, think issue is related to these drops...BR-FW01/pri/act# capture asp type asp drop-allBR-FW01/pri/act# show cap asp117 packets captured 1: 05:22:07.983652 802.3 encap packet Drop-reason: (l2_acl) FP L2 rule drop 2: 05:22:...
Hi KrishnanWe are currently checking the link between the HQ and branches as it appears to be related to that. I will post update once confirmed. Thank you for support.
Hi richbarb Thanks for clearing the above question as I too was two-minded about the compatibility. I have another question I need to clear from my mind , does the XFP-10G-MM-SR support regular LC fiber patch cord? I will be connecting from "XFP-10G-...
