Policy Based Routing with the Multiple Tracking Options Feature Configuration Example - CiscoMethod 1route-map alpha permit 10!--- Define a route-map to set the next hop depending on !--- the state of the tracked routers.set ip next-hop verify-availa...
is there need to configure auto-qos and manual qos in N7K having VPC and Catalyst 3850 having VSS ?if so,how to configure auto-qos and manual qos in in N7K having VPC and Catalyst 3850 having VSS ?I prefer using DSCP
when there are only 4 x 10G port and 24 x 1G port,should peer-link of VPC and virtual-link of VSS use fastest port one 10G , two 10G or just normal speed port 2 x 1G channel group?
vpc downstream devices only need configure feature lacp , then port channel no need further command to configurehow about VSS case?how to configure downstream routers to use uplink devices which VSS?
sacrifice 2 x 10G originally for uplink been peer link when only 2 x 10G left for uplink , is it worth to do that? do peer link require huge bandwidth ? is data traffic going through peer link all the time?
You said both diagram shown layer 2 switch , but internet vlan and SAN vlan should be different , if it is not a layer 3 router , how can other access switch can find the route through these layer 2 switch to SAN network?the diagram look like layer 3...
is there any reason such as looping, speed , security or whether prevent route flapping, vlan flapping etc for choose layer 3 or layer 2 port channel ?