Hello,I currently have an 1121 acting as a bridge to allow my wireless clients to connect to the internet via an 871. I want to upgrade my WAP to a model that supports Wireless N and WPA2. The most affordable model I can find is the AIR-LAP1142N-A-K9...
Hello,I am working on an issue where I see errors on the interface...Serial0/1/1:0 is up, line protocol is up Hardware is GT96K Serial Description: Connection to TP Provider MTU 1500 bytes, BW 1984 Kbit/sec, DLY 20000 usec, reliability 255/2...
Hello,According to this...http://www.ciscocapital.info/en/US/tech/tk722/tk809/technologies_configuration_example09186a008054339e.shtmlI should be able to config WPA2 on an 1121AP when using 12.3.8 JED but I get this error...ap(config-if-ssid)#authent...
Hello,I am trying to upgrade a stand alone 1121 AP's (bridging, not controlled by a WLC) security config from WEP to WPA2.I found this guide for the 1310...http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008054339e...
Here you go, thank you!ap2#sh controller dot11radio0!interface Dot11Radio0Radio AIR-MP21G, Base Address 000f.24e4.1fb0, BBlock version 0.00, Software version 6.11.6Serial number: ********Number of supported simultaneous BSSID on Dot11Radio0: 8Carrier...
cisco AIR-AP1121G-A-K9 (PowerPCElvis) processor (revision A0) with 15138K/1236K bytes of memory.Processor board ID ************PowerPCElvis CPU at 197Mhz, revision number 0x0950Last reset from power-on1 FastEthernet interface1 802.11 Radio(s)Here...