Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone arrived at a working method to audit the contents of a policy-map or class-map using baseline templatesb? I've tried to treat these as ordered-lists much like an ACL, but have not been met with much success (The compliance-check returns no...
Hi,I need to schedule a automated periodic squeeze of a filesystem <don't ask... long story> on a 4500 switch running 12.2(31)SGA code. Problem is, the squeeze command has an interactive "...Continue?" prompt, which requires a simple <CR> to proceed....
Hi,I'm wondering if anyone has figured out a way to check the compliance of multiline configuration entries (banners being a great example)? We have a corporate standard MOTD banner, and I'm looking for a way to make sure its audited as part of our e...
Hi,Was wondering if anyone has any good tips for troubleshooting the cause of job failures for the RME ArchivePoller and ArchiveUpdate jobs. We're running LMS 2.6 on Solaris and the scheduled jobs seem to be failing consistently. What seems a bit odd...
I Have a Cat6k (SUP1A/MSFC2) running IOS 12.1(20)E doing eBGP with several ISPs. BGP sessions have been up and running for quite some time just fine. Recently, I made a change to the neighbor inbound route-maps and removed the "set weight xxx" statem...
We've experienced that Z3s upgrading to MX 18.107 (from 17.02.10) are unable to pull a DHCP lease on port 5 (the PoE port) on the Z3 appliances post-upgrade. Rolling the impacted appliances back to the prior release (17.02.10) fixes the issue, and re...
Most definately. The Catalyst 4948 platform running IOS 12.2(54)SG1 is also vulnerable to bug CSCtg62793. Unfortunately, the bugID currently does NOT list 12.2SG as vulnerable and only mentions the Cat3750 as being affected. This really needs to be u...
Hey Joe,I recently ran across this same doc online as well and wasted some *serious* time trying to get it to work (we're running LMS 2.6) until I opened a TAC case (# 606650565, if you're interested) and found out its not supported until RME 4.1 (LM...
Interesting indeed. Switching to the '"' character for a delimiter seemed to resolve the issue. When I was using '^' for a delimiter (as I always have in the past and as is also the listed example delimiter character in any IOS device), I could never...
So, after a little testing, I am running into a slight problem with this. I can now sucessfully deploy a multiline banner using the baseline templates using this method. Problem is, that a compliance check using the same exact template used to deploy...
