Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I've added a CMX to Prime 3.4 but cannot see any Clients on the maps.
Under: Services / Mobility Services / Mobility Services Engines I can click on: Click Here to manage CMX
and added the CMX which is also reachable. But what about the next...
Hi all,
perhaps somebody has some information about that. I need to know the bandwidth lost between 1572 AP's MESH AP's.
Perhaps 1 RAP and 3 MAP hops over 5 Ghz and also what about the bandwith when Client Link (5Ghz) is activated. Which bandwidth i...
Hi all, I have a WGB (1242) which is jumping around to different MESH 1522 AP's.Is it possible to configure the 1242 only to connect to the nearest MAP?He is always jumping to MAP's and RAP's which are more fare away with a very bad signal; Don't kno...
Hi all,I need the information about how to upgarde from PI version 1.4 to the new version 2.1.Is it possible right now and if not, when will it be possible?THX!!!
HI,Just want to know how many WLAN can be configured on a WLC 5508 and also how many SSID's? I found that the maximum of 16 SSID's can be on one AP, other SSID's on different AP's with ap groups... is there a list where to compare these informations ...
Hi CMC....
Thanks a lot for your explanation.
I got it only working in version 17.9.4 with the most deafault config --> default AP join profile to support Mesh
I took the config if someone needs a proper default config.
BR
S.K.
Hi B A,
Could you solve the issue? I'm right now at the same point with my 2 x 9124. In Version 17.6.6 it was not possible to change the AP mode, then I did the upgrade to 17.9.4 which solved the issue.
Which documentation did you use for the mesh co...
Hi all,
I faced that issue on a 9800-L-F with version 17.3.6. Does anybody has some news about it? Does it impact the network? Or can it be ignored?
Upgrade needed? Some news from Cisco?
Thx
BR
Steve
Hi Rasika,
On CMX I can see the clients on the maps, but I was thinking that CMX is also like a MSE in the background. So that means that the feature to see client location on Prime maps is not anymore supported in CMX? What about on a DNA Center?
...
