Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, Currently have a cisco 887VA which supports ADSL technology which is in use atm and is VPN'ing to our Datacentre's ASA's. It's using Dialler 0 for the ADSL/Internet connection of which the CryptoMap is using for the VPN connection and also do...
Hopefully someone might be able to shed some light on some networking issues I am having. Our routing core is nexus 5ks, however to a remote site we have a 100Mb full duplex private microwave/wireless system that is used for dataprotection/backups. ...
Hi All,Product in question: ASA5512-x in HA Active/Standby Failover modeWhen running a ping from the inside network to a device on the internet I recieve replies and all is good. However when running a traceroute from inside the network to a device ...
Hi All, First time poster so hope I have located this in the correct thread etc I am very new to BGP routing and am in need of help with the following:BGP has been setup between our Nexus 5k core's ISP router for our private IP network managed by the...
On another note, I just had the thought that Instead of trying to use this 887VA router, I Could use the Meraki MX64 I already have and get it to connect to the ASA for the time being. Once we have the new Meraki MX100's in at the Main Office DC on n...
Hi Joeseph, Thank you for your reply, appreiated. I have played with the max size on the output queue and have limited the drops, however I think I have both a traniset burst as well as sustained congestion occuring. The Increase in max output queue...
Hi Ryan, Thank you for the response. It's starting to make sense for me slowly. I was leaning to that packets dropped due to the interface essentially being flooded, or as you put it bugger was full. I am not sure what buffer this device and will ...
Hi Jouni,Thanks for all your help with these issues, it has helped a lot. I would agree with your comments on the ASA showing in traceroute. I tended to think before your reply that this is not something would normally do as it is a security device...
Hi jouni,Thanks so much, all makes a lot more sense now, it was staring me in the face but I didn't see it. First time playing with ASA here 1 more question, I notice that the ASA inside and outside IP's don't show in the traceroute, from some info ...
