Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I have a customer with over 150 access points that needs to be setup in flex-connect mode. Usually I choose a separate subnet for APs and SSIDs of /23 or .24, here they have some limitations with vlan/IP subnets available for use.
So I am ...
Hi, Is there a command on WLC to check the current active radius server in the list?I have configured multiple radius servers and noticed in the logs the radius servers were often deactived and activated. I would like to see which is the current acti...
Hello All, Does web authentication work perfectly fine while locally switching the SSID on Hreap mode APs with older WLC firmwares - 7.0.98.218. I see it is supported in 7.0.116.0 onwards. Does it work on older versions? Has anyone tested and faced a...
Hello All, We are facing a wierd issue where the Windows 7 laptops are unable to connect to the corporate Wifi automatically. We have pushed the profiles using Group Policy and there are about 15 profiles present on each laptop. The SSIDs are not bro...
Hello, I am thinking of upgrading the WCS to Cisco Prime NCS in our environment, but i read NCS is replaced by Prime infrastructure. Now I am confused if I should go for the NCS or Infrastructure. Can someone please suggest the best option for a smal...
Thanks. The issue that we have is that some clients never show up on the WLC. So its not an issue with EAP. Either the clients are not probing or the APs are ignoring the active probe requests from clients. Is there anyway i could find this without b...
Hello Scott, I am unable to set the policy to 2.4 only since there are a lot of APs sharing the controller and dont want to bump off all the clients that are able to client.Today tried upgrading a cleints wireless NIC drivers and that didnt make much...
Yes, the SSIDs are configured to connect even if not broadcasted.I came across and XP machine today that has Centrino 6300 Advances N adapter which didnt see the network.We are running code 7.0.98.218 on all controllers. Majority of APs are in H-REAP...
