Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I have one scenario and please help:- I have 14 x 50m lightmask outdoor and all install HP AP 330 (end of life). The existing diagram as below:+ Client connect to AP HP330 by 2.4 Ghz -- connect by cabling 1gbps to Allied outdoor --> connect t...
Dear all, My customer uses 7 x SG550x-48P and connect full to 250 Camera. All SG550x is stacking and from Access switch will have 2 link 10GB to connect to 2 Core Switch. All camera is Avigilon with image Full HD. Now, the problem is with 250 camera,...
Hi all,
I am going to buy 300 AP3802E and 10 controller CT3504 for 10 branches. I will deploy each controller to manage 10 AP or 30 AP or 50 AP depends the size of each branches. All controllers will run standalone.
So, could you know how the licen...
Dear anyone, I have some question about the ISE solution: 1/ If we use Dlink access switch or unmanaged switch (linksys of cisco), we can use ISE solution and ISE can control which the devices put in the network and apply policy to other devices (iph...
Dear anyone,In my network:- at HO: 2 x WLC 5500 and 20AP, ACS, AD- at branches: 5 AP at each branchI configure the H-Reap. Now, I have some question about Cisco wireless:1. Only 1 Wan link between HO and branches, How I should configure when the WAN ...
Thanks a lot for your answer. However, I would like to make clearly on this scenario (you can refer to picture attachment) AP Outdoor 1560E has 2 antenna: 2.4 ghz and 5 ghz. AP-1 and AP-2 connect to Outdoor switch by copper cable and has a optical ca...
Dear anyone, I can configure the authentication for HO and branches at WLC at HO. If the WAN link down, all AP at branches will authenticate local at Local AP at Branches? That is rights? AP will support how many local authentication?Thank you very m...
Thank you very much. In WLC, I configure SSID for each AP. For example: I have SSID 1, SSID 2, SSIDn; I only want AP 1 for SSID 1 and AP 2 for SSID2. Can I do that?Best Regards, Duy Khang
Another case: I use Wireless Controller at HO and use Access Point at branches. Now, I want IT at Branches that can create key for guest at Branches. IT at branches will log in to web portal of Wireless Controller and generate key. I can configure th...
