Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have ACS 5.1 running in. I have scheduled backups on it through GUI. However, I realized that scheduled backup doesn't work at all though manual backup from GUI works fine and saves file on configured FTP server/path. So that means there is not...
Hi,I am working on lab setup where I installed ACS 5.2 I created new access service and used it in existing service selection rule (Rule-2) earlier but it didn't work. Later I created new service selection rule and applied new service access rule. Ho...
Hi,I am looking for an IKEv2 supported IOS for 7200 router to test FlexVPN on GNS3. I searched on Cisco tools and found c7200-advsecurity-15.2(4)M suitable for working on FlexVPN and IKEv2. However when I tested it on GNS3, it doesn't support ikev2 c...
Hello Guys,I am trying to allow skype communication through ASA firewall. In current scenario I need to allow all TCP ports or TCP port 80 to allow skype but that gives users access to every URL on Internet. So I want to allow skype application only ...
Hi,I am having PIX ver 8.0I want to allocate 512kb bandwidth for inbound remote access VPN users accessing LAN network behind PIX. My PIX is acting as VPN server and users on internet.Can someone help me guide how to configure it using modular policy...
Thanks Karsten for your response. I did check CSR 1000V and tested on Virtualbox but unfortunately I couldn't find ikev2 support in IOS. IOSsing is version I am using is csr1000v-universalk9.03.12.00.S.154-2.S-stdScreenshot attached for your referen...
Yes indeed, skype suggests to open all ports.I am surprised to see Cisco do not have any solution for blocking/allowing skype specifically. I thought it is possible through the use of modular policy framework just as blocking yahoo/im.
I think you should try telneting on port 3389 (RDP port) on server 10.42.11.32 from the source. If that works fine then FWSM context configuration should be fine.Also try doing samething from the system in the same subnet of 10.42.11.32 to verify i...
