Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,we have every day some "bad People" how want to use our VCSE for calling PSTN numbers.It is possible to configure the firewallrules via Xconfiguration or only over the web-page ???thanksStephan
Hi @ allwe want to change the PIM-DR in a MPLS MDT enviroment.Aktual alwas the PE with the hightes IP Address would be choosen for the DR.We want to add some new PE´s outside our Campus, so we want do define the PE who is the DR.HSV-2b#sh ip pim vrf ...
Hi,We want to user more than 255 MDT Data per VRF.If we configuring more than 255 we get an error Message on the CLI. Is this the maximum per VRF ??What is the maximum MDT Data on a Sup 720 3B.ThankStephan
Hi Chris,Thanks for the Answer. That is what i want to do. Block "bad" sip calls. I Think that CPL was only for Call Manipoulation (Chaning the destination,....). (Never stop learning)Now I go in the deep with the CPL´s to Block the "bad" SIP-callsS...
Hi Rodolfo,I made the update.In our system the port range are the same as in 7.2.2 (50000-54999)I check the new version on our VM-Ware server and only a new installation uses the new Ports.I hear no negative response from the user and the firewall te...
Hi Craig,After we have a similar issue we doing some tests. We find out the all Access Switches 2950, 2960-S, 3550, 3650 and 3750 are flooding the Multicast to every port in the Vlan, if there is no IGMP-querier in that Vlan. Following configurations...
