Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have a SIP Cube at a remote branch office (London).CUCM running 9.1 at Hub location (US)London Phones and London SIP Trunk from CUCM to CUBE are in same device pool/region etc. Remote branch 7965 phone dials outbound (which will use the London CUBE)...
All,Have remote branch office phones connected to CUCM 9.1. Just transitioned to SIP service via CUBE in this branch office. Have outbound calling functioning properly (calls stayed connected until hung up). Inbound calls drop at 15 minutes.In troubl...
Experts, I’ve recently installed a pair of 5525X’s in transparent mode to protect some internal segments. In reading about transparent mode I thought I read that the ASA will “proxy” the connection when going from the Layer 3 side (North) to the ...
I let MARS auto discover a large chunk of my network. In doing so, the reporting interfaces of those devices is not what I want them to be (it added them with the Ethernets not the Loopbacks which it uses as source-interface for logging etc.) I was w...
I have a question on the ?Topology Discovery? piece in MARS. I will be using SNMP to discover and poll all devices in the network. What I don?t want is the MARS box to scan entire subnets looking for devices. I want to control exactly what MARS is do...
Hi Daniel, How many sites are you planning to deploy? We're looking at between 7,000 and 8,000 sites. What kind of device were you thinking of using at the Hub location(s)? We're trying to find a datasheet or some other document that outlines ...
Thanks David, Would it be safe to assume that a "HUB" type vEdge device would have the same scaling limitations as the vSmart controllers previously mentioned.One TLOC - 5400 vEdgesTwo TLOCs - 2700 vEdgesThree TLOCs - 1800 vEdgesIn the hierarchica...
Question around control machine limits and ztp: We’re looking at a fairly large SD-WAN rollout and I was wondering on limits of the controllers around bfd sessions, control connections etc. We’ll most likely have a hub and spoke type configura...
I removed the codec list and replaced with a list allowing only G711ulaw / G711alaw and still received the "Media Not Acceptable" message.Hardcoding the codec's to either G729 or G711 had the same "Media Not Acceptable" result.Only having the inbound...
After the pnreset, if I then load from the seed file, do I need to do anything besides "activate" it? The manual refers to "check it's connectivity or perform discovery".Can I also take all networks out of the "Valid Networks" section of "Topology D...
