Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Looking in the documentation for configuration registers I see definitions for bits 0 through 15, except for bit 4. That means the second nibble can have values 0, then 2-F from what I can tell. Is there a definition for bit 4 being a 1? Thanks in ...
In the ICND2 training manual it's specified that the U/L bit is set to 1 for global scope and 0 for local scope. However, the diagram didn't seem to be clear about which bits were which (all it says is U/L bit 000000UG - what's G?). So I hit the we...
I am using a cisco WS-C3548-XL running IOS (tm) C3500XL Software (C3500XL-C3H2S-M), Version 12.0(5)WC17, RELEASE SOFTWARE (fc1).In the documentation I see the command to change which version of spanning-tree is (config)#spanning-tree mode xyzOn t...
Tracy, I've run into the same thing you are (although I know this is two years after the fact). I discovered here that the ports we're talking about are related to telnet streams on rotary ports.Table: TCP Port Telnet Access to Cisco Products (Earli...
Thank for the reply, Peter. As I'm studying for my CCNA I don't think I'm going to need the layer 3 features of a full-blown 3550T. Would the 3550-SMI series do?
Yeah, I finally figured it out when I was examining the results for the first hop from Corerouter.It says 1 p1r2 (192.168.1.225) 8 msec p1r1 (192.168.1.201) 12 msecWhat confused me is a Cisco traceroute doesn't do what a Windows traceroute does...
