Hello Muthukumar, So you have 2 routers connected to your provider. Also there are 4 interfaces on this device configured for VRRP group 1, this might cause conflict as the VIP address will have 4 differents IP addresses, such a thing is not possible...

ARP packet are contained in the same broadcast domain, a router is a device that limit the broadcast domain. So this means that the ARP packet generated by the host A will not go beyond Router A. As Bhishma mentioned, the ARP will be replied by the R...

Hello Tareq, Instead of use IP SLA ICMP-Jitter, you might try withIP SLA ICMP Echo which include a command called "request-data-size": (Optional) Sets the protocol data size in the payload of an IP SLAs operation's request packet. Example: Device(co...

Hello Bryan,If you mean that you want to change the Management VLAN from 1 to another number, I might say yes, but make sure to reach the IP address of the SVI that you want to telnet.Take a look at this link, this has 3 options to configure this:Con...

Hello Jose,Check this support forum, it might help you:https://supportforums.cisco.com/thread/2178146